Strawberry Dreams
This tut assumes your have a Good working knowledge of PSP.

Kit: Strawberry Dreams by Creative Scraps by Crys you can purchase this kit here
Tube: Elias Chatzudis you can purchase this tube here.
This is a limited additon tube if you purchase 4 tubes you get this one free,
offer open until October 31st.
Please do not use without a licence.
Mask:None
Template:Punky Butts, Template # 84, you can download this and lots of other templates here

Fonts: Respective, you can download here
Shadow: 2,2, 36, 6
Filters: DSB Bright Noise,
PSP Filters used: None

sa-f-df-nl= Select All, Float, Defloat, New Raster Layer.
sa-f-df= Select All, Float, Defloat.
c/p= copy & paste
sa=select all
sn=select none

See finished tag for placement of tube/elements.

Let's begin.
Open your tube and template, duplicate the template and close the original.
In your template delete the following layers, Credits, Middle Square, Film Strip Frame, Film Strip Backing and Middle Square Frame.

Starting from the bottom of the template select Left rame Circle layer, sa-f-df-nl, c/p paper 14 into selections,
sn, delete template layer, apply DSB Bright Noise setting 37-Mix, repeat the above steps for the remaining Circle frame layers.

Select Left Circle layer, sa-f-df-nl, c/p paper 18 into selctions, sn, duplicate this layer, Image Mirror and move it above the Right Circle layer in your layer pallet.

Select the Left Diamond Line Style layer, sa-f-df-nl, c/p paper 16 into selections,sn, delete template layer, add Bright noise filter again using the same settings as before.
Duplicate this layer, Image Mirror, delete the Right Diamond Line style layer.
Add a slight drop shadow to both of these layers, I used 1, 1, 35, 6.

Select the Center Cirlce, sa-f-df-nl, c/p paper 16 into selections, sn.

Select the Right Square Frame layer, sa-f-df-nl, c/p paper 16 into selelctions, sn, duplicate this layer Image Mirror.
Delete the Left Square Frame layer.

Select the Left Square layer, sa-f-df, c/p paper 18 as a new layer, move the paper so that the red part of the paper fills the selection, selections Invert, hit delete, selections invert again c/p close up of tube as new layer, position, Invert selections again and hit delete.
Change the blend mode to Hard Light.
Duplicate your tube layer and your new left square layer, Image mirror to both layers.

Make sure that both these layers are above the Right Square layer.

C/P tube I resized 90%, sharpen once.

Add your elements, I used the following:
Greenery,
Red Petals
Light @ 50%
Strawberries 50%
Doodle @ 35%

Add your copy right and text.
All done.